Incl. VATExcl. VAT

Powrmatic Remote Sensor

£35.00 Excl. VAT

The Powrmatic remote sensor is compatible with the MC200 and MC300 controllers only. Sense temperature in a remote location. Provides a more accurate room temperature when located away from the heater.

SKU: Powrmatic Remote Sensor MC200 MC300 Category:

Description

Powrmatic Remote Sensor (Wall)

The Powrmatic remote sensor is compatible with the MC200 and MC300 controllers only.
The remote sensor is a low voltage device and is powered directly by the controller.

 

Powrmatic Remote Sensor
• Sense heat remotely from the MC200 / MC300 Controller
• Enable controller to be located in an office or locked room
• Low voltage wiring for easy installation
• Simple pair of wires and screen for installation

Powrmatic Remote Sensor

Cable Requirements
We recommend that the Powrmatic remote sensor be installed with a screened cable.
A typical example would be a Belden 8442 or equivalent.

Installation
The Powrmatic Remote sensor has a screw holding the front panel in place.
Carefully remove the screw and retain.

Fix the Powrmatic remote sensor enclosure to the wall using appropriate tools and equipment.
Run the cable from the heater to the remote sensor.
Ensure that the cable is fixed as necessary and generally fitted in a good manner.

Carefully strip the external sheath from the cable and remove any foil if necessary.
Fit a ferule to the two conductors if available.
Sheath the earth and leave disconnected.
Wire the two cables to the terminals inside the Powrmatic remote sensor.
There is no polarity so wires can be connected either way around.
Replace the cover on the sensor.

Route the other end of the cable to the heater.
Isolate, lock off and test electrical supply is dead.
Check for auxiliary control feeds, isolate, lock off and test for dead.
Fit a stuffing gland and route the cable to the heater chassis.

Strip the end of the cable as above.
Locate the two terminals labelled COM and IN2.
Note that the internal sensor will share the COM connection.

Wire the pair of cables to COM and IN2.
Carefully wire the screen to a suitable earth point.
Generally, fitting and stripping a longer length of cable, will provide a longer sheath earth.
This will be neater when fitted than using connector blocks or similar.

Once the wiring is done, replace all access panels on the heater before turning back on.

Using a thermostat, make a note of the temperature at the Powrmatic remote sensor.
Enter engineer mode on the controller. See the manual below for assistance.
In the engineer settings, locate the sensor options and configure for Sensor 2.

You can now trim the displayed temperature, to that shown on your thermostat at the sensor.

The MC200 / MC300 will now sense the temperature of the Powrmatic remote sensor.

 

Take a read of the MC300 information below on how to use the controller.

 

Delivery
UK normal delivery charges are INCLUDED within this price, excluding some areas of Scotland & Ireland (contact us for additional costs). Lifting equipment is required to unload product at destination and should be arranged before delivery. Tail Lift delivery can be arranged at an additional cost if required.

PDF Brochure Download
Please click on the image below to download a brochure for the Powrmatic MC300 Controller range in PDF format.

MC300 Product Range Brochure (PDF)

Powrmatic MC200 Trade Brochure Thumb

MC300 Internal Cabinet (Pre-Installed) User, Installation And Service Manual (PDF)

Powrmatic MC200 Internal Instructions Thumb

MC300 Standard Wall Controller User, Installation And Service Manual (PDF)

Powrmatic MC200 Standard Instructions

Please contact us for more details, or click here to visit the Powrmatic website.

 

Reviews

There are no reviews yet.

Be the first to review “Powrmatic Remote Sensor”