Combat Flue – Aluminium – Cabinet Heaters
Combat flue in this section can only be used with Combat Gas warm air cabinet heaters.
The single skin flue system is made from Aluminium and available with a range of accessories.
The Aluminium flue is suitable for only Gas Heaters, models 15, 20, 30, 40 and 50.
DO NOT use this flue on larger gas or oil cabinet heaters as permanent damage to flue and heater will occur.
Flue is available in two sizes to suit a limited range of cabinet heaters, please check on the following table to confirm flue size.
You must order a cabinet adapter to allow the aluminium flue to be fitted to the heater correctly.
This flue system should only be installed in a vertical arrangement using a suitable flashing for roof penetration.
Adequate protection should be considered as the aluminium flue is not as mechanically strong as stainless steel flue.
Available Flue Components
- 1000mm Aluminium Flue Pipe Section
- Cabinet Adapter (One Required Per Heater)
- 45 Degree Flue Bend
- Master Flash Seal With Fixing Kit
- Gas Terminal
A Cabinet adaptor is required to allow the use of Aluminium Flue with the Gas Cabinet heater.
It is not permissible to use 90 Degree fittings on cabinet heaters. Wall penetrations should be made using 45 Degree elbows which facilitate combustion gas flow.
When a section of flue pipe has been cut to size, any off cuts should be disposed of. A factory seal is installed in one end to form a socket.
Shipping is included free of charge when purchased with an appropriate heater.
When purchasing flue separately, a carriage charge will apply depending on the amount of flue purchased.
Small amounts can be shipped by carrier, large amounts will be shipped by Pallet service.
Please contact us to agree a shipping charge for flue purchased individually.